===== Fabric-Duino ===== {{ :arduino_clones:fabric-duino_011229.jpg?400 |}}\\ The Fabric-Duino is an Arduino clone for fabric. And for connectors one can make small wire eye.\\ {{ :arduino_clones:duino-shirt.jpg?400 |}}\\ All Paper-Duino version will works as well, but the smaller version is much handier.\\ ---- ==== Paper PCB ==== {{:arduino_clones:fabric-duino_02.jpg?300|}}\\ {{ :arduino_clones:fabric-duino_02.zip |}}\\ ---- ==== Workaround ==== 01. Iron the printout on fabric:\\ {{:arduino_clones:fabric-duino_01_174501.jpg?200|}}\\ 02. Cut a Copper-Stripe-Board to the right sice:\\ {{:arduino_clones:fabric-duino_02_181905.jpg?200|}}\\ 03. Solder all parts:\\ {{:arduino_clones:fabric-duino_03_194424.jpg?200|}}\\ The back should looks like that:\\ {{:arduino_clones:fabric-duino_03_back_194449.jpg?200|}}\\ For wireing parts like LEDs and switches one need some Conductive Thread and a needle.\\ ---- ==== Software ==== One should first burn the bootloader on the chip: [[avr_bootloader:bootloader|Burning the Bootloader]]\\ For uploading a scetch one need a Serial to USB board or: [[arduino_clones:serial_adapter|The Arduino as a Serial Adapter]]\\ ---- ==== Parts ==== * Atmega328 * 1 LED * voltage converter 7805 * crystal 16MHz * 1 elkos 100µF * 4 capacitors 100nF * 2 capacitors 22pF * diode 1N4007 * resistors: 1x 330Ohm, 2x 470Ohm, 1x 10kOhm * push button * pin headers & sockets * battery clip ---- ==== License ==== The Fabric-Duino was designed by **Wolfgang Spahn** 2017.\\ It is licensed under a [[http://creativecommons.org/licenses/by-nc-sa/4.0/"|Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License]].

----