===== Motor Control Board ===== This board is for two DC motors (5-40V) in combination with an Arduino. You can control each speed with one PWM and each direction with 2 digital ports.\\ - Forward: ON - OFF\\ - Stop: OFF - OFF\\ - Backward: OFF - ON\\ Two control LEDs indicates the PWM. And the other four indicates the direction of the motors.\\ With the jumper one can power the output with an external power supply or - for testing purposes only - via the arduino. {{ :arduino_boards:motor_control_board_02.jpg?300 |}}\\ {{ :arduino_boards:motor_control_board-back_1263.jpg?300 |}}\\ ---- ==== Paper-PCB ==== {{:arduino_boards:motor_control_board_21_pub.jpg?200|}}\\ {{:arduino_boards:motor_control_board_21.xcf.zip|}} ---- ==== Code ==== {{:arduino_boards:motor_control_board_test.zip|test program}} ---- **Components** * 1 H-Brigh Driver L298 N * 6 standard LEDs * 1 elkos 2200µF * 2 capacitors 100nF * 8 diodes 1N4007 * resistors: 2x 2,2kOhm, 2x 220Ohm * pins and jumper ---- ==== License ==== The Motor Control Board was designed by **Wolfgang Spahn** 2011-16.\\ It is licensed under a [[http://creativecommons.org/licenses/by-nc-sa/4.0/"|Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License]].

----