===== Confetti 116 Chua's Diode ===== That's an other [[https://en.wikipedia.org/wiki/Chua%27s_diode|Chua's Diode]] board for the analog computer [[analog_computer:analog_computer_main|Confetti]].\\ With the jumper set one can connect the output to the common ground, if no jumper is used one can use the output connector instead.\\ In combination with the [[analog_computer:confetti101_gyrator|Confetti101 Gyrator]] one can build a [[https://en.wikipedia.org/wiki/Chua%27s_circuit|Chua's Oscillator]].\\ {{:analog_computer:chua_s_circuit_134511.jpg?600|}}\\ [[https://dernulleffekt.de/doku.php?id=analogcomputation:01_chuascircuit#analog_computation_01_-_chua_s_circuit|Analog Computing 01 - Chua's Circuit]]\\ ---- ==== Paper PCB ==== {{:analog_computer:confetti116_chua_s_diode_ii_01.jpg?400|}}\\ {{ :analog_computer:confetti116_chua_s_diode_ii_01.zip |}}\\ ---- ==== Parts ==== To build this board one needs a copper stripe protoboard (1/6 of the 16x10cm board), a paper print out (1:1) and some copper wire for the bridges.\\ * **Resistors:** * 2x 220 Ohm * 1x 2.2 kOhm * 1x 3.3 kOhm * 2x 22 kOhm * **Semiconductors** * 1x TL072 OpAmp * **Mechanical:** * 1x IC socket, 8pins * 1x 2 pin strip * 3x 2 pin header, female * 2x pin header, female 90° 1x3, 1x2 * 2x pin header, male 90° 1x3, 1x2 * 1x jumpers ---- ==== License ==== The Confetti116 Chua Diode was designed by **Wolfgang Spahn** 2020.\\ It is licensed under a [[http://creativecommons.org/licenses/by-nc-sa/4.0/"|Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License]].

----